Model assessment · Fujitsu / PFU (Ricoh)

Fujitsu fi-4640S A3 simplex document scanner review

An earlier SCSI-2 flatbed and simplex ADF scanner. Fujitsu documented a 100-sheet Letter/A4 load at 17 lb, but current host compatibility, seller condition and package are unknown.

Sources checked 2026-11-03 · Our editorial approach

PFU America lists fi-4640S under Production / Discontinued for Service. The historical U.S. sheet names CG01000-492501; verify the seller's exact nameplate and package. The roster's fi-7700 replacement link is not evidence that the models are equivalent.

Review the exact model, limitations and buying checks on BuyerShortlists before choosing a seller. We may earn from qualifying purchases.

Official image of the Fujitsu fi-4640S scanner body with ADF and flatbed
Official fi-4640S model image · package not shown PFU/Ricoh Global exact-model archived product page
A useful fit for

A narrow fit for a buyer who has a tested compatible SCSI-2 host and needs an A3 flatbed plus simplex ADF on older equipment; verify the exact unit and its legacy software before relying on it.

The main tradeoff

This is an earlier, no-longer-service-eligible, simplex machine with a 50-pin SCSI-2 route rather than documented USB or Wi-Fi. The feeder figure is stock/size dependent, its manual-feed mode is not a special-original bypass, and current drivers, unit condition, package and service are unknown.

Your needs, this model

Does it fit your priorities?

Is the fi-4640S a USB scanner, or does it require a SCSI host?

The exact U.S. sheet lists SCSI-2, and the operator guide specifies a half-pitch 50-pin interface. It does not establish USB. The optional third-party-slot board is not an assumed standard part and cannot operate at the same time as SCSI-2. Verify the actual port, card, cable, termination, host and driver on the seller's unit.

Explore this need in the finder →
Does its manual-feed setting provide a separate route for special originals?

No separate bypass is established. The manual's manual-feed mode means the operator inserts the next page into the same ADF during an ongoing job; it is not documented as a separate route for every envelope, card or fragile sheet. The glass flatbed is a distinct option for suitable individual originals, subject to the guide's handling notes.

Explore this need in the finder →
Does the fi-4640S hold 100 A3 pages in its feeder?

No. The U.S. sheet and guide rate 100 Letter/A4 sheets on a 17 lb basis; the guide says capacity changes with paper size and ream weight. Do not transfer the 100-sheet figure to A3/11x17 originals or treat it as pages per day.

Explore this need in the finder →
Does its TWAIN listing prove it will work on a current computer?

No. The historical U.S. sheet lists TWAIN/ISIS drivers for Windows 98, 2000, NT and XP. That does not demonstrate a working installation with today's OS, a named capture application, available SCSI controller or transferable software license.

Explore this need in the finder →

The Fujitsu fi-4640S is an earlier A3-capable flatbed and simplex ADF scanner built around a legacy SCSI-2 host path. It is not a plug-in USB or wireless desktop scanner, and a historical TWAIN/ISIS listing does not establish a modern driver or host fit.

Identify the model, not the replacement pointer

PFU America still names the fi-4640S on its U.S. discontinued-for-service roster, under Production. The roster says that group is no longer eligible for extended service. Fujitsu's historical U.S. data sheet identifies the model and gives part number CG01000-492501. That part is useful when comparing an old seller claim, but it does not prove the nameplate, contents, condition, service rights, or working state of a particular item.

The roster link leads to a fi-7700 replacement page. That is not evidence the two machines share a chassis or features. This assessment uses the fi-4640S's own U.S. sheet, operator guide, and exact-model archived Global page; another seller model should not inherit these facts.

Two paper paths, but only one side at a time

The fi-4640S combines a flatbed with an automatic document feeder. Fujitsu lists originals up to 11.7 by 17 inches on the ADF and flatbed, so the glass can accommodate suitable bound or fragile originals that do not belong in a feeder stack. The ADF, however, is simplex: it captures one side during a pass, not both sides automatically. People digitizing double-sided records need a deliberate second-side workflow in their capture software or another manual pass; the glass is not a duplex shortcut.

The published maximum is 100 Letter/A4 sheets at the stated 17-pound basis. It is a per-loading figure, not the separate historical “up to 6,000 pages a day” duty statement or a test of a used unit. The guide says capacity changes with size and paper weight; do not transfer the 100-sheet figure to A3 or heavier stock.

Fujitsu's U.S. data sheet gives up to 40 pages per minute at 200 dpi on A4 portrait, while the operator guide's mechanical table and the archived Global page report 45 ppm on a nominally similar basis. Those sources conflict. I do not average them or treat either as a measured end-to-end result; capture software, host processing, media, maintenance, and the feeder's actual condition would all matter.

SCSI-2 is the central compatibility question

The U.S. sheet specifies a SCSI-2 interface, and the model guide describes a half-pitch 50-pin connection. It does not document a standard USB host route. A contemporary computer may lack an appropriate controller, connector, supported driver, or a workable bridge. Confirm the exact interface on the unit, identify a compatible SCSI card and cable, check termination requirements, then demonstrate a scan with the intended host and capture application before buying. A “TWAIN” label alone is not enough.

The historical U.S. sheet lists TWAIN and ISIS drivers for Windows 98, Windows 2000, Windows NT, and Windows XP, and names Kofax Adrenaline separately. That is valuable evidence about the original software environment, not current OS support, an available installer, an app pairing, or a transferable license. No phone/tablet route, Wi-Fi path, or direct cloud destination is established by the exact model sources.

There is an option board slot, but it should not be treated as a bonus interface. The operator guide says an installed third-party-slot board and the SCSI interface cannot be used simultaneously. The exact board must be identified, and its availability and host route verified; the base SCSI profile does not imply a board is in a seller's package.

Manual feed does not mean a special-original bypass

The old U.S. sheet lists a “manual feed mode,” but the model's operator guide describes it as a setting that lets the operator insert the next item into the same ADF during an ongoing job before the paper-empty timeout. That is not evidence of a separate feed path designed for envelopes, plastic cards, folded originals, or every delicate sheet. For a suitable fragile or irregular original, the model has a separate flatbed; use the guide's media restrictions and choose the glass when the ADF is inappropriate. The questionnaire's special-original manual-feed requirement is therefore not counted as a match.

Size, lifting, and age-related checks

Fujitsu lists the body at 27.4 by 20.5 by 9.2 inches and 46.3 pounds. These are not installation clearances or proof a used package contains a hopper, stacker, power cable, SCSI accessories, or manuals. Confirm the footprint, lifting arrangements, and each included part with the seller.

For a used machine, request a readable nameplate and a live demonstration of the flatbed, simplex ADF, controls, and intended SCSI host. Ask about pick-roller and pad replacement, feed errors, glass condition, service history, return terms, and what software/media actually accompanies it. The U.S. roster's service wording is not a promise of support for a second-hand buyer. A source image can identify the model's appearance, but it cannot verify seller condition.

Who should consider it

This model is worth investigating only when a buyer has a proven compatible SCSI-2 environment, can run its verified driver/application path, and values an A3-size flatbed alongside a simplex feeder on existing equipment. It is a poor default for a new office, a USB-only laptop, mobile scanning, automatic duplex, or a buyer who expects current driver support or a complete ready-to-run package. A different replacement model may be a better lead, but its specs and offer need their own review.

This assessment is based on the cited manufacturer sources. It does not report hands-on testing, ownership, personal use, a verified offer, a present price, or a tested current-host setup.

Sources checked: PFU America's U.S. discontinued scanner roster; Fujitsu's exact-model fi-4640S U.S. data sheet and operator's guide; and the archived Global fi-4640S page. The latter warns that its information may be out of date; the U.S. PDF files were inspected in the official reader after direct retrieval returned a generic HTTP 429 challenge.

Key specifications

Key details at a glance

Scanner classProfessional departmental flatbed adf
Automatic document feeder capacity100 sheets
Optical resolution400 dpi
Connection optionsSCSI-2
Automatic duplex captureNo
Separate manual-feed routeNo
TouchscreenNo
TWAIN driver documentedYes

Use the exact model’s instructions for operating limits, supplied equipment and version differences.

Sources for this review

Sources for this assessment

Compare the workflow before you choose

Use the finder to test your connection, paper and software requirements against the documented scanner arrangements.

In this review

Questions to consider for this model

Read the matching requirement, its tradeoffs and the other reviewed options.

More matching requirements
Combine my requirements →